dsp实现液晶显示电子日历画册.docVIP

DSP课程设计 题 目 DSP实现液晶显示电子日历 英文题目 DSP implementation LCD electronic calendar 院 系 专 业 姓 名 班级学号 指导教师 实训地点  摘 要 传统的液晶显示往往采用单片机控制。但在系统有大量高速实时数据的情况下，单片机由于受到处理速度的限制就显得力不从心。为了解决这些问题，本文提出了一种基于DSP控制的液晶显示屏的设计，有效地解决以上所遇到的问题。 本文提出了一种基于DSP控制的液晶显示数字模拟钟的设计。通过对DSP芯片 TMS320L VC5416PGE和液晶模块 LCM12864ZK 的分析和研究 ,利用TMS320L VC5416PGE的 DSP最小系统板构建了一个时间显示系统 ,采用 LCM12864ZK液晶模块显示时间 ,用按键调整时间。该时钟系统包括硬件电路的实现和系统程序设计两部分。对液晶显示时钟系统的硬件原理和主程序流程图进行了介绍 ,并给出了定时器的初始化程序和按照液晶显示模块接口读写时序编写的在 DSP芯片TMS320L VC5416PGE上的液晶显示初始化程序。 关 键 词: DSP ; TMS320L VC5416PGE ;LCM12864ZK液晶模块 Digital simulation clock DSP realized Abstract The traditional liquid crystal display (LCD) often USES the monolithic control. But in the system with a lot of high-speed real-time data, due to a single chip processing speed limit is ragged. In order to solve these problems, this paper puts forward a DSP control based on the design of the LCD screen, effective to solve the above problems. This paper put forward based on DSP control liquid crystal display (LCD) digital simulation clock design. Through to the digital signal processor (DSP) TMS320L VC5416PGE and LCD module LCM12864ZK analysis and research, using the least TMS320L VC5416PGE DSP system board has constructed a time display system, adopting LCM12864ZK LCD module show time, with buttons settling time. This clock system including the realization of hardware circuit and system programming design two parts. On liquid crystal display clock system hardware principle and main program flow chart are presented, and gives the timer and initial program according to LCD module interface, speaking, reading and writing in digital signal processor (DSP) the timing write TMS320L VC5416PGE on liquid cr