K03 Lexium28培训教材 人机界面.ppt

● Using the HMI, you can view and change parameters, field bus parameters, limits and current statuses. Diagnostic displays are also possible. ● Using the HMI, you can view and change parameters, field bus parameters, limits and current statuses. Diagnostic displays are also possible. When the AC servo drive has a fault, LCD display will show the Alarm number.(ALxxx).After switching on the drive, the display will show the current operating mode code for 1 sec., then enter into the monitor mode. In monitor mode arrow key can switch between the several monitor parameter code. After selecting a monitor parameter, the value of this monitorparameter will be shown after approx. 1 sec. In monitor mode, and display a 32-bit data, with you can change between display is high byte or low byte. In monitor mode, with you can change the display between hexadecimal and decimal format. ● In monitor mode pressing key can enter into parameter mode. In parameter mode, pressing key can switch between the parameter group,and pressing can change between the parameter group code.● In parameter mode, the system will enter into the setting mode immediately after is pressed. ● With you can change the parameter value. ● With you can move the cursor left. ● With you can change the parameter setting (blinking digits) ● With you can save the parameter setting. ? When parameter setting is completed the LCD display show “SAVED”, if the value is saved correctly, and automatically return back to parameter mode. ● Monitor Parameters as: P0-00 = Firmware version ● Basic Parameters as: P1-01 = Control Mode and Output direction ● Extension Parameters as: P2-00 = Proportional Position Loop Gain ● Communication Parameters as: P3-01 = Transmission speed ● Diagnosis Parameters as: P4-07 = Input status ● Motion Control Parameters as: P5-04 = Homing mode ● Pr Path Definition Parameters as: P6-04 = Parameter for internal Position