化学工程与工艺专业制图-装配图(国外英文资料).docVIP

化学工程与工艺专业制图-装配图(国外英文资料) This article is contributed by the winter Powerpoint documents may be a poor experience at the WAP end. It is recommended that you choose TXT, or download the source file to the native view. Chapter 10 assembly drawings The function and content of the assembly drawing The throttle valve is a device assembly diagram that controls the flow of fluids as follows: With low: assembly process planning, assembly assembly, is the development of assembly process planning, assembly, inspection, installation and maintenance of technical files of the technical documentation. Technical documents for inspection, installation and maintenance. Content: (1) a set of views. A set of views. (2) the necessary dimensions. The necessary dimensions. (3) technical requirements. Technical requirements. (4) title bar, part number and title bar, detail column. Detail section. Throttle assembly diagram The expression of the assembly diagram I. the rules of painting The surface of the contact surface of the adjacent parts and the surface of the match only draw a line; The surface of the contact surface of the adjacent parts and the surface of the coordinate surface to draw a line; Draw two lines without touching the surface and non-cooperating surface. Draw two lines without touching the surface and non-cooperating surface. Both sides of contact Two sides do not cooperate with each other Adjacent two (or more than two parts, or more) parts adjacent 2. When two or more than two parts adjacency, section line of the inclined direction should be opposite or different between different. It should be different or different. But the same parts must be in the same direction and spacing in each view. The line and the spacing must be consistent. The standard parts and the solid parts of the standard parts and the solid parts are not cut and drawn Two sides do not cooperate with each other Special drawing The dissection of the parts combining the parts Imaginary cutting along the co