志空中调、V款漏水处理小经历(二)(国外英文资料).docVIP

志高空调、V款漏水处理小经验(二)(国外英文资料) In the V kernel series, a leak handling experience (2) The V core series of V in the market has been found to be leaking in the new market, and the water is leaking mainly in the left, middle and right of the wind tunnel. The source of condensate is mainly produced in the auxiliary sink evaporator and the second Angle, and when the machine is running and the wind wheel is turning, the condensation water is blown down by the air flow. Because of the high humidity, or other causes, water droplets can be blown out of the sink to make a leak. The evaporators Angle will be condensed into a negative tank, and when the fan is running at high speed, the water droplets may be blown to the wind channel and the water will leak. Figure 1: condensate blown to the outside of the tank leakage formation, the only treatment method is to improve the height of the auxiliary water tank and the water Angle, Angle of auxiliary water tank of water at the same time also increased. Increase the height of the water board Material: from the old E and V base to remove the water board, the shear length is 57.4 cm, and the width is 2.3 cm, unchanged. The E type of water board is longer, and it will be shorter by 12cm when applied. Figure 2: the material used to increase the height of the water board in the sink, the source of the material: remove the water board from the E F kernel base Newly added auxiliary water board The retaining plate of the original base Figure 3: the E E F of the F in figure 2 is directly stuck to the V water shield. The new baffle can be in good condition with the original retaining plate, and the total height of the new water retaining plate is 3.6 cm. Figure 4: the new baffle can be fully formed with the original retaining plate. After the initial connection, the water board must be kept to the left and right sides of the water board. The height is kept at 3. 6 cm. The left end of the new baffle plate must be in close contact with the left en