我的砖混结构设计总结(国外英文资料).docVIP

我的砖混结构设计总结(国外英文资料) Its going to be different Roof (surface) structure diagram. When buildings are flat roofs, notice the same thing. When the building is a slope roof, the structure is handled in two kinds: the plate type and the folding plate. The plate type is suitable for the flat surface of the building, which is large, the slope of the roof and the slope of the ridge line are complicated. On the other hand, the fold is applied. Both types of plates are eccentricity. When the plate is reinforced, the plate should be partially or fully laminable to resist the pull. The thickness of plate is generally not less than 120 thick. In addition, the layout of the steel bar should be shown schematically. As to the graphic illustration of slope roof board, recommended profile sketch increase the representation method of sample detail (practice proves that this method is convenient for construction personnel understanding drawings). Correct the drawing and design is the key to the designer really knows, structure designers must have a certain space concept, correctly understand architectural drawings and intention. The drawings of the design will be understood by the builder. Because the rise of the roof of the roof will cause the part of the wall of the attic floor super high, should combine the roof of the window to set up the wall to reduce the computation height of the wall. Large details. The drawings of large samples can be drawn directly on the basis of the detailed drawings of the buildings, provided that the detailed drawings are accurate. You can also make local improvements on the basis of the details youve previously made. It is important to keep the structure of the structure as well as possible in order to maintain the structure. Be consistent with architectural specialty in the height and shape. It is important to note that the relationship between the high and the structure is clear. The reduction should not be reduced by any reduction. 4. The stairs. Stair