成本的话题老是这么令人进神(一)(国外英文资料).docVIP

成本的话题总是这么令人着迷(一)(国外英文资料) But there is a loss: do you think the car will give you enough? Impossible! Ill give you 97 percent. Still do not matter, the construction unit still has one recruit: floor board 12cm, the national regulation allows + -5mm, calculate a floor to come down you can press the country to allow the province how much? Im going to go around, just to give you a sense of whats going on in the project. I usually take a 1% loss of concrete. The ratio of concrete is known, the result of analysis is multiplied by the unit price that you investigate! 2) reinforcement: so is the steel bar, using the ruban or the machine (recommended using lu ban, because the machine is not enough for the actual accuracy). If you do not draw the material, you can evaluate it according to the quota. The completion or schedule payment will be adjusted for the same period. And concrete: the cost of labor machinery is temporarily no matter, calculate material cost only, the key is fixed loss, the actual loss is 1%!!! And it is suggested that in the contract with the rebar group, this 1% loss will be destroyed! Even if he is:) because in practice, science is reasonable in the material and feed, 1% of the loss control is not in the words. The quantity of project is come out, combined with the material unit price that you understand and the direction (total price contract is used) multiplication is. 3) outside the frame, an outer layer of the measurement is relatively complicated, because this involves the construction organization design and erection norms of the country and the local security surveillance requirements. Want to know, anhui and zhejiang set-up requirements of different, hangzhou and ningbo, authors specification also have differences, urban and rural set-up requirements of different also. But its basically the same thing. Ha ha. I calculate this measure commonly to press the column distance of 1500mm, a kick pole is a bar to calculate. According to the buildings e