施耐德无线按钮module_3题稿.ppt

XBR5 Implementation March 2011 V0.53 Objectives Summary Review the range and implementation instructions Able to Configure the Receiver Teach / unteach buttons Set outputs Change functions What Is Needed to Follow This Training A Programmable Receiver 2 Transmitter (2 push buttons) The XBR5 Simulator tool Quick Review of the Offer Implementation and Front face Indication Wiring of Receivers Relay output version: PNP output version : (1): For non configurable receiver the fuse is 125mA Transmitter assembly Mounting : similar to Harmony range Fixing the Receiver Screwing mounting Clipped on Rail Din Front Face Indication Teaching and Reception Teaching / Unteaching Reminder: 32 (max number of transmitter per receiver) Teaching: Unteaching With the transmitter Without the transmitter (using ID number) Typical distance transmitter / receiver Usage of a relay Antenna When If the signal strength LED on receiver is yellow Can be installed at any time to increase the reliability of transmission, in difficult environment Implementation : Needs only power supply, no settings Not wired to the receiver or to the transmitter One relay antenna can be used for one or several receivers / transmitters It should be located in order to bypass obstacles Workshops What Do You Want to Learn? Output Modes Monostable Bistable Start / Stop 3 Output Modes / 2 Receivers Type Output Mode: Monostable (manufacturing configuration) One click ? The output close during 500ms Output Mode: Bistable First click ? The output closes Second click ? The output opens Output Mode: Stop / Start (only recommended for simple functions, ie: switch On and Off a resistance) One transmitter closes the output An other transmitter opens the output What Do You Want to Learn? #1 Teach a Button to Q1 Teach the Green Button to Q1 Q1 in Monostable #1 Teach Green Button to Q1 #1 Teach Green Button to Q1: Simulator #1 Teach Green Button to Q1: Video #1 Teach Green Button to Q1: