FLOEFD培训教程全.ppt

* In the Wizard you can also use the Navigator in addition to standard Next and Back buttons. The Navigator provides quick access to dialog boxes or steps of the Wizard. Using the Navigator you can not only correct data specified in any step of the Wizard, but quickly create a new project avoiding the step-by-step process. * The Navigator pane contains following buttons, which provide access to the corresponding dialog boxes of the Wizard: Project Configuration Unit System Analysis Type Fluids Default Solid (If Heat conduction in solids is enabled) Wall Conditions Initial Conditions (Initial and Ambient Conditions for external analyses) Results and Geometry Resolution If you specified all the required data and want to create a new project with the current data, click Finish. * To specify a configuration: 1 Click Flow Analysis, Project, Wizard. 2 Choose current configuration or create a new configuration for the project. ? Click Create new if you want to copy the current configuration and attach a new EFD.Lab project to it. Enter a new Configuration name. ? Click Use current if you want to attach a new EFD.Lab project to the current configuration. If the current configuration already contains a project, the project is replaced and all data will be lost. To avoid the warning message you should Clear Configuration to clear the configuration from a EFD.Lab project before entering the Wizard. 3 Add the desired Comments to the project. After the project is created you can revise comments by clicking Flow Analysis, Project, Edit Comment. 4 Click Next or click the button on the Navigator pane to switch to the corresponding dialog box of the Wizard. * … current configuration of your CAD model … * * * To perform an Internal flow analysis, the model must be fully closed. To ensure the model is closed use Check Geometry External flow analysis concerns flows not bounded by outer solid surfaces, but only by the Computational Domain boundaries. In this case the solid model is f