带中文字库的LCD显示几个字的代码.docVIP

带中文字库的LCD12864显示几个字的代码 LCD12864 with Chinese font for displaying several words of code.Txt Here is the LCD12864 with Chinese font #includereg52.h #include math.h Void lcd_init (void); Void clr_lcd (void); Void send_com (unsigned, char, CMD); Void send_data (unsigned, char, dat); Void chek_busy (void); Void set_xy (unsigned, char, XPOS, unsigned, char, YPOS); Void print (unsigned, char, x, unsigned, char, y, char*, STR); Void printstr (unsigned, char, XPOS, unsigned, char, YPOS, unsigned, char, str[], unsigned, char, K); Unsigned char code buf[4] ={0xbb 0xb6,0xd3,0xad}; / / welcome #define DATA P2 #define CONTROL P0 #define E / / 7 parallel enable signal sbit E = P0^7 #define RW / / 6 parallel read and write signal sbit RW = P0^6 #define RS / / 5 instruction data parallel select signal sbit RS = P0^5 #define PSB 4 / / and / sbit = P0^4 PSB serial interface #define RST 3 / sbit RST active low reset = P0^3 #define SETB (x, y) (x|= (1y)) #define CLRB (x, y) (x= (~ (1y))) #define CHKB (x, y) (x (1y)) /******************** busy measuring **********************/ / / busy measuring subprogram //RS=0, RW=1, E=H, D0-D7= status word /************************************************/ Void chek_busy (void) {unsigned char temp1; / / state information (whether busy) CLRB (CONTROL, RS); / / RS = 0; SETB (CONTROL, RW); / / RW = 1; SETB (CONTROL, E); / / E = 1; Do{temp1 = DATA; DATA=0xFF;} while (temp10x80); SETB (CONTROL, E); / / E = 1; DATA=0xFF; } /******************** write command **********************/ / / write command subroutine / / /************************************************/ Void send_com (unsigned char CMD) / * * / write command { Chek_busy (); CLRB (CONTROL, RS); //RS = 0; CLRB (CONTROL, RW); //RW = 0; DATA = cmd; SETB (CONTROL, E); //E = 1; CLRB (CONTROL, E); //E = 0; } /******************** write data **********************/ / / write data subprogram / / /************************************************/ Void send_data (unsigned, char, DAT) { Chek_busy (); SETB (