迈腾电气系统5.pptVIP

主动巡航内容 系统概述 功能描述 ACC 传感器 雷达系统基本功能 操作 组合仪表显示 CAN 信息交换 调整 功能图 功能描述 功能描述 功能描述 被动 ACC 显示 主动 ACC 显示 驱动总线切断继电器 调整 调整 调整 电话准备系统 充电器 (选装) 安装充电器支架 取下充电器支架 蓝牙电话系统匹配过程 (Azimuth) horizontal adjustment (in Y-axis): turn S2 (Elevation) vertical adjustment (in Z-axis): turn S1 The 3 sensor holders must be renewed if detached. 3个传感器支架拆开后必须更换。 In measured value block 6, the setting values for the azimuth offset and the elevation offset are shown in degrees. 在数据块6中，水平偏转和垂直偏转角度用度来显示。 For ACC adjustment, values 2 and 3 in measured value block 6 are of interest.对于调整ACC，数据块6中显示区2，3的值非常重要。 A declination of 0.1° = 4mm offset of the reflected laser beam on the setting motor. (Multiply value by 40 to gain mm equivalent) On the setting monitor, on the right-hand side (as seen in direction of normal travel) from where the co-ordinates originate, is the positive area of horizontal alignment (negative values of left-hand side). The part of the co-ordinates system located beneath the y-axis symbolises all positive values in vertical alignment (negative values in upper half) Declination: Interrogate declination between mirror axis to radar axis from ACC control unit. Mark the calculated value on the target plate and adjust the laser beam with the aid of the setting screws to the marking. The multi-function steering wheel - System overview多功能方向盘概貌 Data is exchanged between the multi-function steering wheel and the steering column switch module via LIN data bus.数据通过LIN总线在多功能方向盘和转向柱控制单元间传递。 The signals from the control unit for the steering column electronics are transmitted via CAN data bus to the diagnosis interface for the data bus. 转向柱控制单元通过CAN总线将数据传到诊断接口。 From there they are forwarded to the respective control units.诊断接口在继续将数据传到相应控制单元。 The functions of the multi-function steering wheel are activated as soon as the ignition is switched on.只要点火开关打开，多功能方向盘的功能就被激活。 Design : “MFA button integrated into the MFL” Rocker switch, OK adopt functions of MFA button (telephone, M