理光1115P复印（Ricoh 1115P copy）.docVIP

理光1115P复印（Ricoh 1115P copy） Ricoh 1115P copy SC541 according to all key reaction to yellow This is the problem of fixing... You press the yellow red 1-0-7- seconds into the maintenance mode in 5#-- (801) 810# 1 YES, then at the same time according to the concentration of the Dodge button and photo mode button in #.. key switch machine can be (801) is full, can not tell the 810 in (801)... Below is the fault code maintenance Ricoh 1015 fault code into the maintenance mode: Yellow 1-0-7- red SC-101 light exposure error seconds SC-120 scanner error in situ 1 SC-121 scanner error in situ 2 SC-122 scanner error in situ 3 SC-123 scanner error in situ 4 Communication error between SC-130, BICU and SBU SC-192 automatic SBU adjustment error SC-194 SBU white level detection error 108: adjust the soft start of the fixing [0= 1s /1=3 seconds] 109: check the fixing band SP2 (drum unit) 001: bias adjustment of charging roller [1] printing level [-2100--1500/-1700/1V/] [2]ID sensor graphics [0-400/300/1V/ level] 101: delete the border adjustment [1] head edge [0-9/3/0.1MM/ level] [2] tail edge [0-9/4/0.1MM/ level] [3] left edge [0-9/2/0.1MM/ level] [4] right edge [0-9/2/0.1MM/ level] 201: adjust the development bias [1] printing grade [-1500--200/-650/1V/] [2]ID sensor graphics [-2=LL:220V/-1=L:260V/0=N:300V/1=H:340V/2=HH:380V] 213: toner near the amount of copies after use [0=50 page, /1=20 page] 214: the initialization of the developer initializes the toner voltage provided by the TD sensor [0= no, /1= is] 220:TD sensor output display Error analysis of 221:ID sensor [0= no, /1= is] SC-302 charging roller leakage SC-320 multi angle mirror error SC-321 no laser write signal (F- gate error) SC-322 laser sync error SC-390 TD sensor error SC-391 display bias leakage SC-392 TD sensor initial error occurred SC-401 transfer roller leakage error 1 SC-402 transfer roller leakage error 2 SC-001 main motor lock SC-503 paper tray lifting motor fault SC-504 paper tray lifting motor failure SC