逆流再生离子交换器使用说明书精要.docVIP

逆流再生离子交换器 Countercurrent regeneration of ion exchange 使用说明书 Operating Instruction 一、工艺原理echnical principle 逆流再生离子交换器（分阳床、阴床、钠床亦称软化器）为无顶压逆流再生固定床，用于软化水、除盐水的制备；在制水工艺上采用逆流制水。 Countercurrent regeneration of ion exchanger (, anion exchanger, sodium ion exchanger is also called sodium softener) for no roof pressure countercurrent regeneration fixed bed, used to soften water, in addition to the preparation of brine; On the water making process by water flow system. 当离子交换器出水再生工艺采用无顶压逆流再生，具有操作简单、外部管系简单、不需要任何顶压设施，投资省的优点。再生时，稀释好的再生剂由下向上逆向流经树脂层，将从下到上依再生不同层态的树脂，这种方式可以使树脂层获得较好的再生效果，再生剂可以得到较高的利用率，其次，具有废液排放量少,自用水率低等优点。 When ion exchanger regeneration process using no roof pressure water countercurrent regeneration, with easy operation, simple external piping, do not need any jacking facilities, the advantages of saving investment. Regeneration, dilute good regenerant from down to up reverse flowing through the resin layer, the state of different layers from bottom to top in accordance with the regeneration of the resin, this way can make the resin layer to obtain a good effect of regeneration, regeneration agent can get higher efficiency, second, with less waste emissions, the low water use ratio etc. 二、技术参数Technical parameters 进水浊度Influent water turbidity： 1-2 NTU 出水水质ffluent turbidity 强酸阳床：钠泄漏不大于100ug/l，一般在20-30ug/l Strong acid cation exchanger 强碱阴床：SiO2泄漏不大于100ug/l，一般在20-50ug/l,出水电导率 10us/cm。 trong alkali anion exchanger:SiO2 leakage is not more than 100 ug/l, generally in the 20-50 ug/l,effluent conductivity 10 us/cm. 软化器： 出水硬度 20ug-N/l。 odium softener:Effluent hardness 20ug-N/l. 工作压力orking pressure: 0.6MPa 工作温度: 5-45℃ 运行流速Operating velocity: 20-30m/h 水反洗强度Water backwashing strength: 阳树脂ation resins 10-15m/h 阴树脂 resins 8-10m/h 再生流速egeneration velocity: 5m/h 再生液浓度Renewable liquid concentration: 1-3% 软化床的食盐浓度可适当加大 填料高度Packing layer height: 1600mm（cation exchanger）00mm（ exchanger） 10．承托层etainer layer： 层次 （自上向下since the last down） 尺寸 （mm） 厚度 （mm）