大鼠脑基底动脉最适初始张力的确定.docVIP

大鼠脑基底动脉最适初始张力的确定.doc

  1. 1、有哪些信誉好的足球投注网站(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。。
  2. 2、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载
  3. 3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
  4. 4、该文档为VIP文档,如果想要下载,成为VIP会员后,下载免费。
  5. 5、成为VIP后,下载本文档将扣除1次下载权益。下载后,不支持退款、换文档。如有疑问请联系我们
  6. 6、成为VIP后,您将拥有八大权益,权益包括:VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
  7. 7、VIP文档为合作方或网友上传,每下载1次, 网站将根据用户上传文档的质量评分、类型等,对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档
查看更多
 大鼠脑基底动脉最适初始张力的确定# 肖雪,平娜娜,李森,曹蕾,曹永孝** (西安交通大学医学院药理学系) 5 10 15 20 25 30 35 40 摘要:目的:确定 SD 大鼠脑基底动脉收缩的最适初始张力。方法:将大鼠脑基底动脉制成 1~2 mm 长的环段,用两根钢丝悬挂于 Myograph 恒温浴槽中。将 IC1/IC100 值设置为 0.6~1.0, 记录其相对应的初始张力。在不同的初始张力下,记录 60 mM KCl 诱导的收缩力,研究诱 导的最大收缩力与初始张力的关系。结果:随着 IC1/IC100 值从 0.6 至 1.0,脑基底动脉初始 张力逐渐从 0.47±0.01 mN/mm 增加到 2.68±0.03 mN/mm,对 IC1/IC100 和初始张力进行相 关性分析,相关系数为 0.95,表明二者正相关。KCl 诱导的收缩力先随 IC1/IC100 值升高而 升高,当 IC1/IC100 值为 0.9、初始张力为 1.63 mN/mm 时,KCl 诱导的收缩力达到最大,其 值为 6.51±0.05 mN/mm,明显高于 IC1/IC100 在 0.6 和 0.7 时的收缩力(P0.05)。此后, 随着 IC1/IC100 值的增加,KCl 诱导的收缩力不再增加,反而呈下降趋势。结论:大鼠脑基 底动脉环的最适初始张力为 1.63±0.01 mN/mm。 关键词:药理学;脑基底动脉; 初始张力;肌张力描记系统;大鼠 中图分类号:R965.2 An optimal initial tension of rat basilar artery in wire myography XIAO Xue, PING Nana, LI Sen, CAO Lei, CAO Yongxiao (Department of Pharmacology, Xi’an Jiaotong University College of Medicine, Xian 710061) Abstract: Objective: The present study was to determine the optimal initial tension in rat basilar artery. Methods: Rat basilar arteries were cut into approximately 1~2 mm, threaded on two thin wires (40 μm in diameter), and mounted in myograph baths. Normalization procedure was carried out. IC1/IC100 was set from 0.60 to 1.00, and the initial tensions were recorded. KCl 60 mM was added into the baths to induce a contractile tension. Results: The initial tension of basilar artery increased from 0.47±0.01 mN/mm to 2.68±0.03 mN/mm as the value of IC1/IC100 increased from 0.6 to 1.0. The correlation coefficient between IC1/IC100 and initial tension was 0.95. At first, the contractile tension was elevated with the value of IC1/IC100 and initial tension increasing. When the IC1/IC100 and initial tension reached to 0.9 and 1.63 mN/mm, the contractile tension reached its maximum value, 6.51±0.05 mN/mm. Then the contractile tension started to decrease as IC1/IC100 or initial tension increased. The contractile tensions in IC1/IC100 value of 0.9 was significantly higher than in the IC1/IC100 value of 0.6 and 0.7 (P0.05). Conclusion:.The mo

文档评论(0)

文档分享 + 关注
实名认证
文档贡献者

该用户很懒,什么也没介绍

1亿VIP精品文档

相关文档