变参数深刻钻削分析研究.docVIP

更多相关文档资源请访问/lzj781219 完整CAD设计文件以及仿真建模文件，资料请联要The study of changed deep drilling holes Abstract：The study of changed deep drilling holes is a new method to working deep holes. Such as，normol methods have some prolem，the error f the pore diameter，drill life and burrs are presented.As a result，the advanced technological effect of varying-parameters-vibration drilling is proved. The study of changed deep drilling holes take the advanced govenments.It is a new technology and method .Before drilling,it have a small feed,so that ,there have a lot of time to increce the acuracy.Present investigation shows that the new method for vibration drilling,in which vibration parameters are changed with the optimal parameters of the stages,is an effective way to decrease error of drilling deep holes. Basing on the tudy of changed deep drilling holes,wo can study more things about the drilling deep holes. Key words; vibration drilling;deep holes；location accuracy 目 录 1 引言…………………………………………………………………… 1 1.1 本课题国内外动态……………………………………………… 1 1.1.1 优化设计方法……………………………………………………………… 3 2 钻入中的定位误差………………………………………………………………3 2.1 变参数振动钻削入钻机理………………………………………………… 4 2.2 入钻定位误差的结论……………………………………………… …………4 2.3 变参数真的钻削机理………………………………………………………… 5 3 钻中的排屑和断屑………………………………………………………………7 3.1 有利于断屑和排屑的几个因素………………………………………………8 3.2 断屑条件及切屑长度的控制…………………………………………………11 3.3 基于上述分析的变参数深孔加工方法………………………………………16 4 钻出过程中的出口毛刺…………………………………………………………17 4.1 变进给量振动钻削机理………………………………………………………17 4.1.1 变参数振动钻削提高出口毛刺的结论……………………………………18 5 变参数深孔加工提高表面粗糙度的分析与研究………………………………19 5.1 变参数振动钻削降低表面粗糙度的机理……………………………………19 5.1.1 变参数振动钻削提高表面粗糙度的结论…………………………………20 6 变参数深孔振动钻削装置的介绍………………………………………………21 6.1 常见的几种振动钻削装置……………………………………………………21 6.2 变参数振动钻削的一些工艺参数……………………………………………27 7 变参数深孔钻削系统稳定性的研究……………………………………………30 7.1 振动钻削的断屑机理…………………………………………………………30 7.2 变参数振动钻削系统的动力学模型以及系统的稳定性……………………32 8 变参数深孔钻削系统加工深孔的结论和展望…………………………………31 参考文献……………………………………………………………………………32 致谢…………………………………………………………………………………34 1 引言 1. 统的深孔加工存在钻入定