Φ液压翻倒离心机设计.doc

摘要 该毕业设计题目是Φ800液压翻倒离心机的设计。在张建伟老师的悉心指导下，我进行了转鼓壁的厚度计算，拦液板的计算，转鼓底的设计，功率计算和电动机的选择，传动皮带的设计及选择，主轴的设计和强度校核，轴承的选择，翻到架的设计和强度计算，刹车的结构设计和强度计算，翻倒传动部分的设计计算，和其它的一些设计计算。 在设计中，我首先要了解到离心机的工作原理：先由控制电路接通带动转鼓转动的电动机，通过皮带的传动使转鼓转动，转鼓转动使物料固液分离，液体通过离心机底部的排液管流出，固体留在转鼓壁上，然后再由控制电路接通翻倒电动机使离心机翻转倒出固体，这样就完成了分离的整个过程，这也是我们设计必须明白的。然后使了解离心机的各个零部件的构造和它们的材料工艺要求。最后对离心机进行整体的评定。 关键词： 离心机；转鼓壁；转鼓底；主轴； Abstract The graduation project entitled Φ800 machine overturned centrifuge design. I was the drum wall thickness, the board of the bar, the drum at the end of the design, calculation and electrical power of choice, transmission belt of the design and selection, Spindle in the design and strength check, bearing the choice, turn-the design and strength, braking and intensity of the structural design, overturned part of the design of transmission, and a number of other design and calculation. Zhang jianwei teacher the guidance of well。 In the design, I would first need to understand that the centrifuges working principle: first control circuits connected to the motor rotating drum driven by the belt drive to drum rotation, rotating drum so that materials from solid to liquid, liquid by centrifugal - Ranked at the bottom of the outflow of liquid, solid remain in the drum wall, and then overturned by the motor control circuits connected centrifuges to Dispose of solid turnover, thus completing the separation of the whole process, which is designed to be Understand. And then to the various components of centrifuges to understand the structure and process their materials requirements. Finally, the centrifuges to conduct an overall assessment。 Key words ：Centrifuges; drum wall; spindle; 型号FD800 名称；液压翻倒卸料离心机 原始数据 转鼓直径： 800mm 工作转速： 1000r/min 物料密度： 1.1010kg/m 最大加料量: 170kg 启动时间： 60～120s 固液比 ： 1：1 设计专题： 离合器组件与底座结构设计 一．用途 本型离心机是近几年设计的必威体育精装版产品，它大大的改善了工作条件，提高了工作效率，同时可以避免刮刀卸料刮破 滤布，以及可以避免破坏物料