Femap_v10.2_Meshing Toolbox教程.pdfVIP

Femap v10.2 Update Training – The Meshing Toolbox The Meshing Toolbox Introduction In this exercise, you will familiarize yourself with the new controls available in the Meshing Toolbox:  Feature Editing  Geometry Editing  Mesh Surface You will also use other Meshing Toolbox controls to complete this exercise. 1 Femap v10.2 Update Training – The Meshing Toolbox Step 1: Open the Femap model and modify the two holes on the right face of the part. Start FEMAP v10.2 and import a FEMAP Neutral File.  Select the File, Import, FEMAP Neutral command.  Select the file, Fitting.NEU  Click OK to accept the default options in the Neutral File Read Options dialog box.  The resulting Femap model should appear as below.  If the Meshing Toolbox is not activated, open it by clicking on the Meshing icon on the Panes toolbar. Note: In Femap v10.2 there are two new Femap Preference options for the Meshing Toolbox under the User Interface Tab: Expand Active Tool Only and a setting to select between Auto Remesh , Track Changes or Disable Remesh . 2 Femap v10.2 Update Training – The Meshing Toolbox Active the Feature Editing controls.  Click on the Feature Editing control to expand it. If the control is not shown in the Meshing Toolbox , you must select the Toggle Tools icon and enable the Feature Editing control. Change the diameter of the two holes on the right face of the part from their current diameter of 5 (mm) to 7.5.  With the Selection Method set to Feature Edges, click the Resize Hole button.  Enter a Diameter of 7.5.  With the Remesh M