Control of Power Inverters in Renewable Energy and Smart Grid Integration电力—ch19.pdfVIP

19 Parallel Operation of Inverters Inverters may have to be operated in parallel directly or indirectly. How to share the load among the inverters operated in parallel is a challenging problem. The synchronverter discussed in Chapter 18 is able to share the load accurately. In this chapter, the inherent limitations of the conventional droop control scheme are revealed at first. It is shown that, when the conventional droop control scheme is adopted, parallel-operated inverters should have the same per-unit output impedance in order for them to share the load accurately in proportion to their power ratings. The droop controllers should also generate the same voltage set-point for the inverters. Both conditions are difficult to meet in practice, which results in errors in proportional load sharing. A robust droop controller is then presented to achieve accurate proportional load sharing without meeting these two requirements and to reduce the load voltage drop due to the load effect and the droop effect. The load voltage can be maintained within the desired range around the rated value. The strategy is robust against numerical errors, disturbances, noises, feeder impedance, parameter drifts and component mismatches, etc. The only sharing error comes from the error in measuring the load voltage. When there are errors in the voltage measured, a trade-off between the voltage drop and the sharing accuracy appears. It is also explained that, in order to avoid errors in power sharing, the global settings of the rated voltage and frequency should be accurate. The cases with R-, L- and C-inverters are discussed, with experimental results provided. 19.1 Introduction There are several reasons why inverters are needed to operate in parallel. One obvious reason is because of the limited availability of high current power electronic devices. Another reason is that parallel-operated inverters are able to provide system redundanc