SNOW LOAD ANALYSIS FOR WASHINGTON（华盛顿雪荷载分析）.pdfVIP

Supplemental Design Examples for the SNOW LOAD ANALYSIS FOR WASHINGTON Second Edition Using SEI/ASCE 7-05 criteria Copyright © 2008 by Structural Engineers Association of Washington All rights reserved. No portion of these notes may be reproduced in any manner without written permission. SNOW LOAD MANUAL ATTACHMENT USER NOTES The design examples within this attachment are intended to supplement the previously published Snow Load Analysis for Washington, Second Edition, published by the Structural Engineers Association of Washington, Copyright 1995 (Snow Load Manual) and the previous supplemental design example problems based on SEI/ASCE 7-02. The examples within this attachment are not intended to change the original example design problem objectives or assumptions. The original design examples are on pages 33 to 44 within the Snow Load Manual, Part III. The original design examples utilized the design criteria given within the 1994 Uniform Building Code (94 UBC), Appendix Chapter 16, STRUCTURAL FORCES, Division I – SNOW LOAD DESIGN. The changes within Appendix Chapter 16 from the 1994 to the 1997 editions of the uniform codes were trivial. Thus, the original design examples were relevant through the use of the 1997 Uniform Building Code (97 UBC). The attached design examples (new examples) follow the original design examples with respect to example number, page number, location within the State, ground elevation, structure type and geometry. The new examples have been designed using the criteria set forth in Chapter 7, Snow Loads, of SEI/ASCE 7-05, the American Society of Civil Engineer