SKY2-Regen故障中文注解.docVIP

AInformation Events 信息故障 000 Power On Power was applied to the drive. 电源适用于驱动器。 001 New Run A new run was initiated. 一个新的开始运行。 002 SPARE Not used. 没有使用。 003 Stack Warn The stack usage has exceeded an acceptable limit. 堆栈的使用已超出可接受的限度。 004 Power Down The power fail signal in the hardware was activated. 电源失败信号在硬件被激活。 005 Extern FLASH The GDCB FLASH memory has failed. GDCB闪存失败。 006 Extern RAM The GDCB RAM memory has failed. 该GDCB RAM内存已经失败。 007 OMU Present Indicates that a valid OMU is plugged into the drive OMU port at power-up. 一个有效的OMU插入驱动器OMU 008 OMU Prohibit Indicates that an OMU software upgrade is prohibited because the previous run was TCI. The status of the permissive can be viewed in the SVT parameter OMU Prohibited. 表明， OMU升级软件被禁止，因为之前已处于TCL状态 这种允许的状态可以用SVT查看数据。 009 Manual Mode Indicates that the drive is in Manual Mode. 表明该驱动器是在手动模式。 010 B_MODE Note: Not supported in this software release. 注：不支持这一软件的发布。 Applicable only in 422-architecture. 只适用于422 Applicable only when “ARO Type” = 2 or 3. 只适用于当“ARO Type” = 2或3 。 Logged when the drive received “B_MODE signal” from Battery controller. 当驱动器受到电池控制记录“ B_MODE信号” 011 Battery Mode Applicable only when Interface Type = 1. 只适用于当Interface Type = 1 。 Indicates the drive is in battery (ARO-EN) mode operating on 48Vdc battery supply. Logged when the drive received SpbMode message “BatteryMode”from SPBC3. 表示驱动器是在电池模式运作得到48Vdc电池供电。该驱动器记录SpbMode从SPBC3收到消息“ BatteryMode ” 012 LearnRun REQ Applicable only when Interface Type = 1. 只适用于当Interface Type = 1 。 Indicates that the floor table in the drive is invalid and that a new learn runis required. 驱动器