炉子安装（Furnace installation）.docVIP

炉子安装（Furnace installation） 1. further confirmation of installation position; 2., out of the box, remove the heating furnace, confirmed temperament is consistent, if inconsistent, should be replaced or recorded; 3. remove the brackets and drawings; 4. installing flue: 5. connect the five pipes in the lower part, and pay attention to the gasket; 6. connect the power supply and the indoor temperature controller. Open the front panel of the machine and connect the power supply according to the N, L and E. Connect the 1-3 contacts according to the temperature controller and put on the panel; 7.: open the tap water inlet and water leakage switch, open the switch to the water heating system, water injection, water injection until 3Bar, close the switch, see if there is a leak, and Caution! Pressure relief valve is opened at the same time; sanitary hot water, to see if there is a leak with soap and water; try whether gas pipeline gas leakage. Turn off the tap water switch, turn on the water injection switch, turn on the faucet, and release part of the water in the heating system until the water pressure drops to about 1Bar; 8. fill in the installation record. So far, the installation process is complete. This section describes the debugging process 1. to open the automatic injection system, exhaust valve exhaust valve and pump radiator on, until the pressure 1Bar, check all pipe connections if there is a leak; open the tap, check all pipe connections if there is a leak; 2. connect to the power outlet and turn on the gas switch; 3. open the front panel; 4. first ignition, Turn the mode selection to summer, turn on the faucet, observe the electronic ignition and ignition; Regulating water flow and regulating hot water temperature control, observing whether or not the flame has changed and changed: the water quantity is large, the flame is large; when the temperature is raised, the flame is big, and the flame is smaller when the temperature is lowered; The mode selection of sp