施工的工艺流程（Construction process）.docVIP

施工的工艺流程（Construction process） Construction process Circuit reconstruction construction process 1, positioning: for various lines shift transformation, should first determine the line terminal socket position, and in the wall marked the exact location and size, and then to the nearest similar socket lead. 2 slot on the wall: should first pop-up control line, and then cutting red marble machines, artificial groove, groove depth should be the same, the straight slot line. 3 add casing: the wiring must be reinforced when installing, and the casing should be tight and smooth. Right angle eight bend should be horn of medial incision, incision in the side arc bending interface after installation. 4 fixed concealed: after the wire is loaded into the sleeve, it shall be fixed with a wire clip, first fixed inside the wall and behind the wall, and then concealed or covered with skirting boards to conceal the corners. The 5 test: all ready and wires and switches, sockets, lamp test connection, wiring to prove correct, will cut through the wall with cement flat. Key points: wire to add casing, should be FireWire, switch, zero line into the lamp holder and left zero right fire provisions of wiring, high power appliances should be set up separately, the strong and weak electricity can not be laid with the pipe. Water, Mason, carpenter continued later! Waterway reconstruction process 1. slotted opening: first according to the design requirement of pipeline transformation, in the center of the wall surface with no marked wall through hole, the cross line written on the wall, with percussion drill holes, hole center coincides with the center line of the pipeline wall. 2.: to pipe water pipe installation will first clean before installation, the installation should pay attention to the quality of interface, and identify the elbow, and the fitting position and orientation to ensure preservation after the installation of water equipment connected to protect the position of right. 3. tes