液压支架操作（Hydraulic support operation）.docVIP

液压支架操作（Hydraulic support operation） Two, operation procedures Send the power to PM32, observe whether the PM32 display is normal or not, if not normal, do it in time. Observe whether the bottom plate is smooth and the roof pressure is too large, so as to decide which operation mode to use. If the roof pressure, broken, uneven floor, you may not use linkage, support group up operation. Single frame non automatic control Operation procedure: The first step: choose the frame according to the number of 1 keys (select left frame) or 2 keys (which selected digital frame) The second step: send operation command: 1) use the keyboard shortcuts to send commands A drop post B key shift C lift column D key shift + lift base E key drop column + lift base F key balance jack 7 button balance jack 8 keys received the first guard plate (for end head for telescopic beam) The first 9 key stretch guard plate (for end frame for stretch shrink beam) L key pushing 2) and other operations: bring up the corresponding menu item, send the command SIDESEAL, IN, OUT, side guard board with K key or M key LIFTING ON lift the base SH-SPRAY ON spray FLIPPER2 IN OUT second retaining panels for extension and extension BALANCE IN OUT carries the inter frame jack or end to side guard plate and extension Be careful： 1, in the whole process of action, we must continue to press and hold the corresponding command button, do not let go, let go of the action, that is, stop. 2, this frame slides, as long as the direct press L key, this frame push slip lasts 5 minutes automatically stop, if you need to stop early, and then press L key. 4, the adjacent automatic sequence (fall - rise -) linkage control Operation procedure: The first step: choose the frame according to the number of 1 keys (select left frame) or 2 keys (which selected digital frame) The second step: press the start button 5 、 group automatic control Operation procedure: The first step: Select function * according to the number 9 key - select aut