解决连续供墨系统墨盒中气泡的四大问题（Four major problems to solve bubble in ink box of continuous ink supply system）.docVIP

解决连续供墨系统墨盒中气泡的四大问题（Four major problems to solve bubble in ink box of continuous ink supply system） Fault phenomenon: This continuous ink system has to work a few months, and now can not be printed. You every day in normal print many times before implementation of the clean command. This print test line is not always a fixed line. I started to print the test line is normal, but after a few pages of print line. This print is always lack of color (usually black) No external cartridges have been placed on low for a long time now, not into the ink inking pipeline. Resolvent： The above malfunction is caused by the ink bubble in the ink box. After six months use, a small amount of tiny air bubbles from the ink and the accumulation of a small amount of air bubbles from the print nozzle into the print cartridge will gradually froth the ink. The method of maintenance is not complicated. Remove the foam and replace it with normal ink. Incorrectly placing an external cartridge down will also accelerate the formation of an ink cavity foam, even if a continuous ink supply system with a EPSON cartridge is used. To eliminate this fault, follow these steps: 1. Remove the continuous ink supply system from the printer. After removal, the ink cartridge should not be inverted. It should be placed on the same horizontal surface as the external ink cartridge. If the sealing plug is used in the initial installation, insert the sealing plug into each ink outlet at the bottom of the cartridge. For the late EPSON cartridges with memory chips, the ink outlet is equipped with valves, so there is no need for a sealing plug. The installation of a new EPSON or being used by the original cartridge in the printer, the cartridge must be open hole, not to inject ink, label the undamaged original cartridge, EPSON genuine can guarantee the correct test results in the test, this step is essential. 2, the printer after the car back, the printer will perform a natural cleaning, please perform nozzle inspec