图层混合模式详解（Layer blending mode）.docVIP

图层混合模式详解（Layer blending mode） If you dont want someone to know, dont do it unless you do. Know me, call my heart sorrow, dont know me, which I want. Picking a chrysanthemum, leisurely to see the mountain. Chant a word, twist the number of broken stems. The wood Spring opens, and the spring flows slowly. On the layer mixed mode, we are often in use, some just feel a layer using the most probably it did not actually happen a mixed mode is good, perhaps after many tests, the mixed mode of all the PS are tried again, finally obtains a good effect. Here, I put these mixed mode systematically summed up, to share with you. Lets get down to business by talking so much nonsense! First of all, lets remember several concepts: (which will be used later) Primary color: the color of the original in the image. Blend color: the color that is applied by drawing or editing tools. Result color: it is the color obtained after mixing. I. normal mode In normal mode, the layer of all pixels, the color is not normal, and the layer below the paths without adjusting the opacity of the layer above, completely covering the following layer, the model is the default value. (normal mode is also called threshold when dealing with bitmap images or indexed color images) As follows: (the picture is just to illustrate, not to make any good results, do not say that they are not good-looking or something like that! The same below) Two. Dissolution model The result of the dissolution pattern depends on the opacity of the layer, and the opacity is reduced to a random dot pattern. The lower the drop, the more pixels on the layer disappear. Usually, when you set the dissolution mode, you will adjust the opacity of the layer, and the effect will be more natural. You can double click the layer to enter the settings window for further setup. Following chart: Three, darken mode In darkened mode, the layer darker than the following layer will be retained, and the place that is brighter than the layer below will