圆方（Elements）.docVIP

圆方（Elements） Normally, the offset value can be entered, or the length of the mouse can be picked up. It may be a problem with your operation. The correct steps are: o- spaces - enter cheap values - spaces - select cheaper objects - point to cheaper directions. The basic steps of square renderings (2006-08-28 22:53:48) classification: the basic steps of software tutorial renderings of the 1. elements to establish the room model and click structure menu build the room - in the plan to use the left mouse button at any point to take that as the basis (to determine the room in the lower left corner position) the length of the room - keyboard input (6000. Note: the length of the garden square is 0 millimeters, and the 6000 is 6 meters, return enter. The keyboard enters the room width (4500), carriage return angle (the default value is 0). The default value is used, and the carriage is returned directly. 2. adjust the display ratio respectively the activation of each view, map button - point zoom button to adjust them to the appropriate size. The 3. generation room contour active plane view, click the structure menu wall line - select all at the exterior wall, enter - line becomes empty, enter - inner wall contour becomes empty, enter K, enter. In this way, the inner wall lines remain as the outline of the room. 4. click on the ceiling menu made the ceiling under the plaster ceiling / roof base - selected room contour line, enter inside the room - click on any point, input ceiling height (2700), enter input - roof thickness (20), enter. The ceiling is ready. 5. click on the ground ground menu ground block, selected room contour line, enter inside the room - click on any point, input ground height (-10), enter - whether the ground grid (the default is no ), by default, directly back to the car. The ground is ready. 6. click on the window menu layout window under the windows Gallery - in the Library Management dialog box under the windows Gallery, click the mouse, select the