搭设方案（The erection plan）.docVIP

搭设方案（The erection plan） I. project overview Jiangsu huayu lighting co., LTD. 8 # industrial plant project, built by Chinas fifth metallurgical construction company. The project is located in the city of danyang, jiangsu province. Project construction unit: jiangsu huayu lamps and lanterns co., LTD., design unit: jiangsu sohe architectural design consultant co., LTD., is supervised by danyang construction supervision center. The construction area of this project is 10056M2, frame structure, floor 2. The total length of the building is 84.5m, and the width of the building is 60M, and the total height of the building is positive and negative zero up to 13.3m (to the top of the parapet). In order to meet the requirements of the main structure and the construction of the outer wall of the outer wall, the requirements of the standardization and qualified construction site in danyang city are guaranteed, and the program is prepared as the basis for construction and acceptance. 2. Master plan According to the construction requirements, according to the national acceptance standards and the relevant regulations of the industry. The following plan is prepared for the construction of the scaffold. The height of the whole building is not too high, and the height of the womens wall is only 13.3 M. So the construction method of floor scaffolding is adopted. Material requirements 1. Pipe material: The steel tube material must be used A3AY3 and meet yb243-63 standard, no.3 steel requirement of gb700-79, 48mm outer diameter, 3.5mm wall thickness, 3.84kg steel pipe per 1000mm length. There must be no cracks, deformations, concave, bending or severe rust. 2. Material of the fastener: The material of the fastener shall be according to the requirements of A3 steel in gb968-67 normal carbon structural steel technical conditions. It is forbidden to use the existing clamps, cracks, deformation rivets, or damaged screws. The fastening distance of the fastener is 39.2-49 n. The clearance of