平弯钢化炉技术规格说明书（Specification of technical specification for flat bending steel furnace）.docVIP

平弯钢化炉技术规格说明书（Specification of technical specification for flat bending steel furnace） QX - GTFB3655S - CV Specifications of flow flat/curved steel furnace technical specifications Model and specification Qx-gtfb3655s-cv for flow flat/curved glass toughened furnace Use and process profile The machine is mainly used to produce glass for large specification of flat/bent tempered glass and other USES. It consists of seven parts: the platoon, the heating zone, the curved section strengthening area, the flat section strengthening area, the unloading platform, the hair dryer system and the electrical control system. The usual process of horizontal bending steel furnace is flat and curved reinforcement, which is located at both ends of the heating zone. In the production of the curved glass, the glass from the platoon of the platoon in the flat section of the reinforcement zone into the furnace, in the heating area heating, after reaching a certain temperature, the rapid release, entering the curved segment of the roll forming and strengthening. When the plate is made of plate toughened glass, the glass enters the furnace from the opposite end of the furnace. After it is out, it reaches the flat wind grate to be toughened, and steel is made out to the unloading platform. The structure of the machine is characterized by a two-way moving function that greatly improves the quality of the glass. Technical, production parameters The local power value Power supply: three-phase four-wire system 380V / 50Hz Power supply capacity: not less than 1400KVA The total power of 1732 kw Heating rated power of 1200kW The rated power of the fan is 250 + 250kW Other 32 kw Processing glass dimensions Plate glass thickness: 4-19mm Processed plate glass maximum range: 3660 * 3660 4mm glass 3660 * 5500-19 mm glass Processing plate glass maximum size: 1000 * 2000mm -- -4mm 1500 * 2500 mm -- -- -- -- -- 5 mm 2000 * 3500 mm -- -- -- -- -- 6 mm 3660 * 5500 mm -- - 8-19 mm Minimum size of processed pla