提车注意事项（Mention the car）.docVIP

提车注意事项（Mention the car） Mention the car 1. Check the certificate instruction 1. Factory date (due within two months); 2. Frame number; Engine number; 4. Product qualification certificate (number and frame number and engine no.); 5. Product description; 6. The model, power, displacement, seat number and engine model are all required to conform to the physical object; 7. Total mileage 50km; Check the main parts of the car 1. Whether the tire is worn: see whether the hair on the side of the tire is intact; 2. Whether the brake disc is worn: if the front brake disc has been worn out of obvious grooves, no 3. Warranty list (the warranty sheet must have a 4S seal, which will prove to be the official product of the 4S, and will be able to enjoy the warranty at other maintenance stations). Check the power, transmission and brake parts: (1) check all kinds of oil products: see if there are oil spots on the ground and oil stains on the chassis. Want to have a crush on, down, left, middle and right, is the engine cover, is under the oil pan, left and right sides is on both sides of the shaft holster, is next to the fly wheel cover lower part, these parts can be seen from a narrow place, the standard is not wet dust ash phenomenon, ground WuYouJi. Pull up the oil ruler (the yellow hand), check whether the oil is clear and the oil is suitable. Pull up the speed box and check whether the gearbox oil is clear and the oil is suitable. (2) the water tank is full and the water pipe is not leaking (3) check whether the battery is suitable, whether the battery connection is corroded, whether the small window is green, whether the battery connection is fixed, and whether there is any sloshing in the other parts of the wire. (4) the belt looseness of the generator and compressor (5) start the engine, the tachometer should be about 1000 RPM, and then smooth down to about 650. Dont hit the gas pedal after the first ignition, see if it will stall automatically (6) the engine sound should