Redis26配置文档.docxVIP

## Generated by install_server.sh ### Redis configuration file example# Note on units: when memory size is needed, it is possible to specify# it in the usual form of 1k 5GB 4M and so forth:## 1k = 1000 bytes# 1kb = 1024 bytes# 1m = 1000000 bytes# 1mb = 1024*1024 bytes# 1g = 1000000000 bytes# 1gb = 1024*1024*1024 bytes## units are case insensitive so 1GB 1Gb 1gB are all the same.# By default Redis does not run as a daemon. Use yes if you need it.# Note that Redis will write a pid file in /var/run/redis.pid when daemonized.daemonize yes# When running daemonized, Redis writes a pid file in /var/run/redis.pid by# default. You can specify a custom pid file location here.pidfile /var/run/redis_6379.pid# Accept connections on the specified port, default is 6379.# If port 0 is specified Redis will not listen on a TCP socket.port 6379# If you want you can bind a single interface, if the bind option is not# specified all the interfaces will listen for incoming connections.## bind 127.0.0.1# Specify the path for the unix socket that will be used to listen for# incoming connections. There is no default, so Redis will not listen# on a unix socket when not specified.## unixsocket /tmp/redis.sock# unixsocketperm 755# Close the connection after a client is idle for N seconds (0 to disable)timeout 0# Set server verbosity to debug# it can be one of:# debug (a lot of information, useful for development/testing)# verbose (many rarely useful info, but not a mess like the debug level)# notice (moderately verbose, what you want in production probably)# warning (only very important / critical messages are logged)loglevel notice# Specify the log file name. Also stdout can be used to force# Redis to log on the standard output. Note that if you use standard# output for logging but daemonize, logs will be sent to /dev/nulllogfile /var/log/redis_6379.log# To enable logging to the system logger, just set syslog-enabled to yes,# and optionally update the other syslog parameters to suit your needs