In-WallWi-FiAccessPoint分析.PDFVIP

In-Wall Wi-Fi Access Point Model: UAP-IW Introduction Thank you for purchasing the Ubiquiti Networks® UniFi® In‑Wall Wi‑Fi Access Point. This Quick Start Guide is designed to guide you through installation and also includes warranty terms. Important: UniFi Controller v5.x is recommended for managing the UAP-IW and is available for download at: /unifi Package Contents In-Wall 802.11n Access Point Model: UAP-IW UAP‑IW Cover Plate Quick Start Guide TERMS OF USE: It is the customer’s responsibility to follow local country regulations, including operation within legal frequency channels, output power, indoor cabling requirements, and Dynamic Frequency Selection (DFS) requirements. Installation Requirements • Pre‑installed electrical wall box • Category 5 (or above) UTP cabling approved for indoor use • Phillips screwdriver • UniFi Switch with PoE Important: The UAP‑IW requires a UniFi Switch with PoE for power. Passive PoE adapters are not recommended. System Requirements • Microsoft Windows 7/8/10 or Mac OS X • Java Runtime Environment 1.6 (or above) • Web Browser: Mozilla Firefox, Google Chrome, Microsoft Edge, or Microsoft Internet Explorer 11 • UniFi Controller software v4.7 or newer Network Topology Requirements • A DHCP-enabled network (for the AP to obtain an IP address as well as for the wireless clients after deployment) • A management station running the UniFi Controller software, located either on-site and connected to the same Layer-2 network, or off-site in a cloud or NOC UAP-IW UniFi Cloud Key (UniFi Controller)