cadkey（国外英文资料）.docVIP

cadkey（国外英文资料） F1 CREATE a sequence of 33413 parallel arrows The 1112-point line 1521 is set at an arbitrary quadrangle 3414 vertical arrows The 112th continuous line segment 1522 is located at the 351 section of the quadrangle 1131 the parallel 153 polygon 353 modifies the section line The 1132 distance parallel 154 grass plot line 371 changes the text property 1141 has a 1611 reverse Angle (trim) 3771 to change the direction of the arrow 1142 dot (not trim) 372 moving text (size) 1143 is the equivalent of 162x right Angle 373 1144 precut and 174 elliptical F4 X - FORM graphic transformation 1145 first hang and then the 1181 polygon is shifted by 4113 1146 the curve is 19111 and the curve is 4123 The horizon of 1151 is 1913 and the end of the curve is 4213 1152 vertical line 193 closed curve 4223 copy move 1153 horizontal vertical line F2 EDIT graphics to EDIT 4313 rotation 116 for Angle ray 211 unilateral pruning 4323 rotation copy The 1171 diagonally is an arbitrary quadrangle 212 bilateral pruning 44113 1172 is a distance from the quadrilateral Trim the middle 4513 mirror for the 118 polygon The radius of the center of arc 215 is 245 216 center with diameter and 216 arbitrary trim F5 FILES management The center of the circle is equal to 221 unilateral interrupts of the 511 memory disk (CTRL + F) 1233:222 bilateral interrupted 5131 1251 with the center of the center of the center of the center of the circle, the reference tuin 223 is cut off the end of 521 PTN 1252 two entities cut arc 224 in the middle 523 open PTN The 1253 3-entity cutter, 225 baseline, interrupts 5813 input IGS 126 start + finish line 226 randomly interrupt 5823 output IGS 127 shunt-arc 231 saves the final delete (CTRL + U) 5822 from PRT to DXF The 128 radius + 2 arc 232 saves the layer 5812 input DXF The center of the circle is 233 and the radius is 233 and the F6 DISPLAY layer is managed The center of the circle is 271 with the diameter of the circle and the moving 661 set of work layer The