CISCO AIRONET 1300使用说明（国外英文资料）.docVIP

CISCO AIRONET 1300使用说明（国外英文资料） This article is contributed by ysl_zxp Doc documents may have a poor browsing experience at the WAP end. It is recommended that you choose TXT, or download the source file to the native view. Technical service center CISCO AIRONET 1300 series outdoor access point/bridge The configuration process 1, connected devices, connect the power supply module and power injector, power will inject USES two coaxial cable to connect to the device, connect, power injection is used straight twisted-pair cable connected to the switch, or the power injection for cross twisted-pair cable connected to the notebook, and Cisco special Console cable connected the power injector and notebook COM port, and then to the power supply module power up Open the Windows operating system super terminal, establish the connection, the connection parameter Settings are as follows Technical service center 3, into A super terminal configuration interface, the user input the enable command mode, enter the privileged mode, the system prompted for A password, the password for the Cisco note: passwords are case sensitive, in privileged mode input B configure terminal command, enter configuration mode, implement the hostname C xx command, set up equipment host name, xx, implement interface for any legal character D BVI1 command, enter the bridge virtual interface, the interface mode performs IP address address mask To set the IP interface IP address E, execute the default - the gateway address command, set the system default gateway address Set the IP address to the same network segment, open the Internet explorer browser, and enter the virtual interface address of the bridge in the address bar Technical service center User name password empty Cisco note passwords are case sensitive 5, click on the EXPRESS SET - UP, check the system Settings, including equipment host name, MAC address, IP address, gateway; The device worker mode, by default, Access Point Technical service cente