PIN FUNCTIONS.docVIP

PIN FUNCTIONS 引脚功能 The device is a serial access memory which utilizes time-sharing input of address information. 该设备是一个串行存取存储器，采用分时输入地址信息。 Command Latch Enable: CLE 命令锁存使：周期 The CLE input signal is used to control loading of the operation mode command into the internal command 周期输入信号是用来控制负荷的运行方式为内部命令的命令 register. The command is latched into the command register from the I/O port on the rising edge of the WE 注册。命令锁存到寄存器的输入/输出端口的上升沿的我们 signal while CLE is High. 信号的同时，明显高。 Address Latch Enable: ALE 地址锁存使：啤酒 The ALE signal is used to control loading address information into the internal address register. Address 啤酒的信号是用来控制加载地址信息到内部地址寄存器。地址 information is latched into the address register from the I/O port on the rising edge of WE while ALE is High. 信息是锁存到地址寄存器的输入/输出端口对我们的上升沿，啤酒是高。 Chip Enable: -1/2 芯片使能：1/ 2 The device goes into a low-power Standby mode when CE goes High during the device is in Ready state. The 该器件进入低功耗待机模式时，行政长官高走在装置处于准备状态。本 CE signal is ignored when device is in Busy state ( RY / BY = L), such as during a Program or Erase or Read 行政长官的信号被忽略时，设备处于繁忙状态（酵母/=1），如在编程或擦除或阅读 operation, and will not enter Standby mode even if the CE input goes High. 操作，并且不会进入待机模式，即使行政长官输入走高。 Write Enable: 写使能： The WE signal is used to control the acquisition of data from the I/O port. 我们的信号是用来控制采集数据从输入/输出端口。 Read Enable: 读使能： The RE signal controls serial data output. Data is available tREA after the falling edge of RE . 在信号控制的串行数据输出。数据可处理后再下降边缘。 The internal column address counter is also incremented (Address = Address + l) on this falling edge. 内部列地址计数器也递增（地址地址+ 1）这一下降沿。 I/O Port 输入/输出端口：8/01 The I/O1 to 8 pins are used as a port for transferring address, command and input/output data to and from 我/O8引脚是作为一个端口传输地址，命令和输入/输出数据和从 the device. 该装置。 Write Protect: 写保护： The WP signal is used to protect the device from accidental programming or erasing. The internal voltage 可湿性粉剂信号是用来保护装置的编程或擦除。内部电压 regulator is reset when WP is Low. This signal is usually used for protecting the