DD6单晶高温合金的等温氧化行为.pdfVIP

Trans. Nonferrous Met. Soc. China 22(2012) 528−533 Effect of spark plasma sintering temperature on microstructure and mechanical properties of melt-spun TiAl alloys CHAI Li-hua1 2 1 1 , CHEN Yu-yong , ZHANG Lai-qi , LIN Jun-pin 1. State Key Laboratory for Advanced Metals and Materials, University of Science and Technology Beijing, Beijing 100083, China; 2. School of Materials Science and Engineering, Harbin Institute of Technology, Harbin 150001, China Received 9 September 2011; accepted 28 December 2011 Abstract: A TiAl alloy from pulverized rapidly solidified ribbons with the composition of Ti−46Al−2Cr−4Nb−0.3Y (mole fraction, %) was processed by spark plasma sintering (SPS). The effects of sintering temperature on the microstructure and mechanical properties were studied. The results show that the microstructure and phase constitution vary with sintering temperature. Sintering the milled powders at 1200 °C produces fully dense compact. Higher sintering temperature does not improve the densification evidently. The dominant phases are γ and α2 in the bulk alloys sintered at 1200 °C. With higher sintering temperature, the fraction of α2 phase decreases and the microstructure changes from equiaxed near γ grain to near lamellar structure, together with a slight coarsening. The bulk alloy sintered at 1260 °C with refined and homogeneous near lamellar structure reveals the best overall mechanical properties. The compressional fracture str