电动葫芦施工方案_secret.docVIP

Construction Plan For Electrical Hoist 电动葫芦施工方案 Contents 目 录 Ⅰ. Project description 工程概况 Ⅱ. Process characteristics . 工艺特点 Ⅲ. Construction preparation 施工前准备 Ⅳ. Construction sequence and technical requirements 施工程序及技术要求 Ⅴ. Trial operation 试运行 Ⅵ. Safety measurements 安全措施 Project description 工程概况 As per design requirements, there will be one set of electrical hoist for 9902 storm water pump house and 9950 FF pump house of china dragon (PMMA6) project separately, and see parameter as followings: 根据设计要求9902雨水泵房、9950消防泵房各设有一电动葫芦,参数如下： No 序号 Unit 单体 Type 型号 Specs 规格 1 9902 storm water pump house 9902雨水泵房 CD1 2T 9m 2 9950 FF pump house 9950消防泵房 CD1 5T 6m Process characteristics: 工艺特点： Electrical hoist is a special set and during assembly, no damage of every part shall be followed; construction and acceptance shall be performed strictly according to equipment technical regulations and code GB50278-98 Code for construction and acceptance of crane installation engineering. 电动葫芦属于特种设备，其组装时应以不得损伤任何零部件为原则，并应严格按照设备技术文件规定及《起重机设备安装工程施工及验收规范》GB50278-98组织施工和验收。 3. Construction preparation 施工前准备 3.1 After electrical hoist is delivered to jobsite, first check to see is there is any damage during transportation and if there is, it shall be repaired immediately and then cane be used. 电动葫芦到达安装地点后,首先应先检查在运输途中有无损坏情况,若发现有损坏情况,应及时修复方可使用. 3.2 Check technical documents for equipment to see if types and specs comply with design requirements and technical safety explanation shall be carried out according to construction plan. 清点设备技术文件，核查设备型号是否符合设计要求，并按施工方案进行安全技术交底。 4. Installation sequence and technical measurements: 安装程序及技术措施： 4.1Installation sequence: construction preparation→check as per packing list and acceptance→installation of electrical hoist→installation of electrical equipments→trial operation and acceptance 安装顺序：施工准备→设备开箱清点和检查验收→电动葫芦安装→电气设备安装→试运验