哈斯操控台培训课件.ppt

  1. 1、有哪些信誉好的足球投注网站(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。。
  2. 2、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载
  3. 3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
* * 当自动软件升级程序运行完毕后,你必须手动再次重启 CNC 记住: 必须用 参数检验程序 检查修正系统的参数和设置,使之与原厂数据一致. Prepared by Haas Automation Service Training Department Oxnard, CA 93030 * * * You can also do a back-up from this page of all the Parameters, Offsets, Variables, Programs, Settings, Alarms, and Automated Too Management. * Refer to the TRM Quick Start Guide for more info on this feature. * Press ORIGIN to clear all the values on a screen. Flutes and Diameter are use for the chip load and surface speed display in Current Commands. Coolant position is for programmable coolant and can be up to 20 depending on type and parameter 206. Some only have 10 positions. A convenient alternative is to use the VQC Probe system. With it, setting tool lengths is automated. Radius Geometry will be used with cutter compensation commands. Wear values will be added to the length and radius/diameter values during program execution. * Here again, you could use the VQC Probe system to automate setting work offsets. * There are also some special screens depending on Options you may have, e.g. Lathe APL, Bar Feeder, APC and for the Laser. * You must use the Right and Left cursor keys to move between the numbers on each page. * * The F2 DISK WR, F3 DISK RD note will not be displayed on this screen, but this should be backed up for software load. * Remember that advertised HP is peak. E.g. a 20 HP spindle can only deliver 20 HP for about 3 minutes (except on the new Vector Drives). You can alter the cutting depth or other variables to change the HP requirements. * This gives you metric to decimal conversion as well as drill and tap size equivalents. * Shown are some important Settings to remember. * This shows the Graphics mode with PROG(RAM) and POSITION selected. F2 and HOME returns zoom to full table view. Graphics can be run in single block and DNC also. POSITION can be set at any of the 4 options with the arrow keys Rapid path and drill points can be turned on or off in Settings. If you encounte

文档评论(0)

a13355589 + 关注
实名认证
内容提供者

该用户很懒,什么也没介绍

1亿VIP精品文档

相关文档