HPc7000安装(值的看一下).pptVIP

Implementing HP BladeSystem Installing the HP BladeSystem c7000 Enclosure and Infrastructure Rev. 7.31 Instructor notes After you power on the enclosure, the Insight Display provides the first access to the enclosure. Remote configuration is not possible until after you run the Insight Display Initial Setup Wizard. The Insight Display Initial Setup Wizard enables the local rack technician to perform the following steps: Select the Power Mode. Set the Limit AC Watts option. Choose a Power Savings mode. Assign the Onboard Administrator IP addresses. Name the enclosure and rack. Assign an Insight Display Lockout PIN. Implementing HP BladeSystem Installing the HP BladeSystem c7000 Enclosure and Infrastructure Rev. 7.31 Implementing HP BladeSystem Installing the HP BladeSystem c7000 Enclosure and Infrastructure Rev. 7.31 Instructor notes A full-height server blade plugs into two device bay connectors and has 32 lanes available to the eight interconnect bays (16 lanes?x 2x in the graphic). Interconnect bays 1 and 2 are reserved for Ethernet switches or pass-thru modules supporting server LAN on Motherboard (LOM) NIC connections to ports on the Ethernet switch or pass-thru module. This means you do not need a Mezzanine card to support an NIC in interconnect bays 1 or 2. Supported bays for additional Ethernet switch modules include unpopulated bays 3/4, 5/6, or 7/8. Redundant switches must be configured adjacent to one another in bays 3/4, 5/6, or 7/8. The full-height blade has four embedded NICs and can accept one Type I or two Type II Mezzanine cards. Each NIC is mapped through the signal midplane to interconnect bays?1 and 2. A full-height server blade installed in device bay 3 would have NICs mapped in the following manner: NIC 1 — Interconnect bay 1 port 11 NIC 2 — Interconnect bay 2 port 11 NIC 3 — Interconnect bay 1 port 3 NIC 4 — Interconnect bay 2 port 3 (continued on the next page) Implementing HP BladeSystem Installing the HP BladeSystem c7000 Enclosure a