DCC安装说明.pptVIP

J 250 SC4 SC26 Fuse holder C 1.0 蓝/黑 2.5 白/紫 B277 32 47 0.35 橙/黑 橙/蓝 B384 B391 J533 T20e/16 T20e/6 34 33 双绞 棕 2.5 16 接地(51) 右后备箱 E387 开关 0.5 397 接地(687) 中控 J519 1.0 棕 T12i/12 6 2 蓝/绿 0.35 0.35 0.35 绿/黑 绿 黑/白 1 4 5 3 21 36 38 5 B340 右后备箱接地 接地点32，主线束 接地点1，中控 B277 连接1(15a)，主线束 B340 连接1(58d)，主线束 B384 连接2，动力can-h B391 连接2，动力can-i 0.35 0.5 黑 灰 G341 G342 G343 G78 G289 G76 N336 N337 N338 N339 左前 右前 左后 右后 1 2 1 2 1 2 1 2 39 40 41 42 43 44 45 46 白 粉 绿 蓝 蓝 绿 红 红 黄 黄 蓝/橙 蓝 绿/橙 绿 左前加速 右前加速 后加速 左前高度 右前高度 后高度 3pin接口 3pin接口 3pin接口 4pin接口 4pin接口 4pin接口 1 2 3 1 2 3 1 2 3 1 2 3 1 2 3 1 2 3 22 7 6 25 10 9 19 4 20 27 26 11 30 29 14 24 23 8 FUSE C 接地点 51 687 接地点 1 J533 J519 E387 J250 FUSE C 接地点 51 687 接地点 1 J533 J519 E387 J250 2.5 1.0 0.35 x2 x2 x4 x4 J250 0.5 0.35 x2 x2 x2 x2 x6 x6 x6 SC4: 刹车灯开关 F 5A 端子15 SC26: 后遮阳帘开关和 控制单元 10A 端子15 18、19、20、21、28、38未占用 Components of adaptive chassis control DCC and fitting locations Caution The body acceleration senders are not allowed to be swapped over. 1 - Shock absorber damping adjustment button -E387- Fitting location: in front of gear lever in centre console Explanations → Chapter 2 - Shock absorber with rear right shock absorber damper adjustment valve -N339-. Removing and installing front-wheel drive → Chapter Removing and installing four-wheel drive → Chapter 3 - Electronically controlled damping control unit -J250- Fitting location: behind luggage compartment trim on right side Removing and installing → Chapter If the electronically controlled damping control unit -J250- is renewed, the basic setting of the adaptive chassis control DCC must be performed. → Chapter 4 - Body acceleration sender, rear -G343- Fitting location: on rear left shock absorber mount Removing and installing front-wheel drive → Chapter Removing and installing four-wheel drive → Chapter 5 - Shock absorber with rear left shock absorber damper ad