AS 3112+A1-2006 试验规格与批准－插头与电源插座.pdfVIP

AS/NZS 3112/Amdt 1/2006-10-11 STANDARDS AUSTRALIA/STANDARDS NEW ZEALAND Amendment No. 1 to AS/NZS 3112:2004 Approval and test specification—Plugs and socket-outlets REVISED TEXT The 2004 edition of AS/NZS 3112 is amended as follows; the amendments should be inserted in the appropriate places. SUMMARY: This Amendment applies to Clauses 2.2.3, 2.8.4, 2.13.1, 2.13.3, 2.13.7.2, 3.6.4, 3.13.1, 3.13.2, 3.14.1, 3.14.2, 3.14.3, 3.14.5, 3.14.10 and 3.14.11 and Figure 2.1 (e), new Figures 2.1 (h), (i) and (j) and Table 3.3. Published on 11 October 2006. Approved for publication in New Zealand on behalf of the Standards Council of New Zealand on 29 September 2006. AMDT Page 10 Clause 2.2.3 N o. 1 1 Item (a), delete first line and insert the following: OCT 2006 (a) Flat-pins with a radius on the end with side bevels, as shown in Figure 2.1(h), may have a— 2 Item (b), delete first line and insert the following: (b) Flat-pins square on the end with corner bevels and side bevels, as shown in Figure 2.1(i), may have a— 3 Item (c), delete first line and insert the following: (c) Flat-pins square on the end with corner bevels and a radius on the sides, as shown in Figure 2.