模板面积计算（Template area calculation）.docVIP

模板面积计算（Template area calculation） 1. The amount of cast-in-place concrete and reinforced concrete formwork shall be calculated according to the following provisions: 1. The amount of cast in place concrete and reinforced concrete formwork shall be calculated in square meters according to the contact area of concrete and formwork. If the contact area of the formwork is calculated with the modulus, the volume of the work is equal to the volume of the member * the modulus of the corresponding item (including the modulus as specified in the appendix). 2, reinforced concrete wall plate, single hole area in 0.3 holes within the rate shall not be deducted, the hole side wall template is not added, but the side wall form prominent wall should be increased accordingly. The single hole area in the hole, outside the 0.3 rate should be deducted, the hole side wall area into the wall, template template engineering quantity calculation. 3, the cast-in-place reinforced concrete frame are respectively calculated according to the column, beam and wall plate, the relevant provisions of the wall engineering calculation of single wall column into the wall, double wall column by column calculation, but the post cast strip, wall engineering amount deducted. 4, equipment bolts, holes or equipment bolts according to different depths to one calculation; two times grouting, according to the actual volume of cubic meters. 5, precast concrete panels or repair cast-in-place joints and crack width in 100mm above, according to the flat quota calculation template. 6. The exposed area of the structure column should be calculated according to the exposed part of the figure (zigzag shape, the width of the template is calculated according to the width of the zigzag surface), the contact surface between the column and the wall is not calculated, and the formwork area is not calculated. 7, concrete awning, balcony, pick the level board, according to the size of the bottom level projection area outside t