精液检验（Seminal Fluid Test）.docVIP

精液检验（Seminal Fluid Test） Seminal Fluid Test I. routine inspection: 1, the amount of liquid inspection [normal reference value]2-5ml. [clinical significance] Which was 1. days if not ejaculation, semen volume and less than 1.5m1 is not normal, that seminal vesicle or have prostate disease; if the semen volume reduced to a few drops, even out, called no sperm disease, in specific infection of the reproductive system, such as tuberculosis, gonorrhea and nonspecific inflammation. Which was 2. if the semen volume too much (over 8m1), is being diluted sperm decreased, impede growth. 2, color check [normal reference] gray or milky white, long ejaculation can be pale yellow. [clinical significance] Which was 1. yellow or brown pus like semen: in seminal vesicle phlogistic or prostatitis. Which was the 2. bright red or dark red bloody semen: in the reproductive system inflammation, tuberculosis and tumor etc.. 3, consistency and liquefaction inspection [] the normal reference value of viscous jelly, 30 minutes to liquefaction. [clinical significance] AP 1. semen viscosity is low, like soup, because the sperm reduction caused in reproductive system inflammation. AP 2. liquefaction time is too long or not liquefaction, can inhibit the activity of sperm fertility, common prostatitis etc.. 4, sperm motility test [normal reference] normal sperm motility is generally at grade III (better activity, moderate speed movement, but more wave motion), more than 1 hours after ejaculation should be 0.60. [] 0 (if the clinical significance of dead sperm, no activity, after heating is still not active) and grade I (sperm activity is undesirable, just spin, swing or jitter, slowness of movement) of sperm in more than 0.40, one of the important reasons for male infertility. 5, sperm motility test [normal reference value] Which was ejaculation after 30-60 minutes of activity for more than grade sperm 0.80; Which was ejaculation within 120 minutes after the activity is more than grade sperm 0.