KV高压开关柜安装调整施工工艺浅析.docVIP

ABB 6KV高压开关柜安装调整施工工艺浅析 敬承风 (山东电力建设第二工程公司 山东省济南市工业北路297号)　　 　 本程序为了确保ABB 6KV高压开关柜（ZS1/ZVC+）安装调整的正确性、安全性、可靠性，规定了6KV高压开关柜的安装工艺、顺序以及施工中应注意的事项。以有效的控制施工过程及质量，确保工程高质量的按期完工。 This procedure specifies installation process, installation sequence and precautions during construction to ensure the correctness, safety and security of ABB 6KV HV Switchboard (ZS1/ZVC+) installation. 1. 6KV高压开关柜安装调整的施工工艺流程图： Process flow chart of 6KV HV Switchboard installation and adjustment as below: 8.2 施工准备 2. 施工准备 Preparation for construction 2.1 施工前仔细审阅图纸，熟悉系统；了解并执行DEP63.10.08.11-CSPC中4.4.1对传导试验的要 求 Check drawings and comprehend the system before construction. Comprehend and conducted the Conductivity tests on main bus bar and earthing bar according to the requirements in Section 4.4.1 of DEP63.10.08.11-CSPC。 2.2了解规范和标准的要求，掌握质量要求和验收标准，编写质量检验计划, 编写及准备符合DL/T 标准的安装记录表；了结掌握ABB的安装和调试手册的要求 Comprehend the requirements of specifications and standards, be familiar with the requirements of quality and standards of acceptance, compile quality inspection plan, compile and preparative form of DL/T standard shall be used to record the inspection and tests performed during installation of switchgear; Read and understood the contents of ABB’s installation and commissioning manual. 2.3 对施工人员进行安全、技术交底 Tell the relative workers their real intentions about safety and technique. 2.4 土建交接验收 Handover inspection for civil construction 检查土建已具备安装条件，并办理交接签证 Check the condition for installation, and transact the visa of handover. 现场安装工作开始时，配电室土建工作必须已施工完毕，照明充足且已送电，室内干燥通风，门、锁齐全；所有与盘柜、电缆施工有关的前期工作已完成；室内条件达到VDE 0670标准1000/ IEC 60694部分对环境的要求，包括室内温度不低于负5摄氏度 On commencement of installation at site, the switchroom must be completely finished, provided with lighting and site electricity supply, lockable, dry and with facilities for ventilation .All the necessary preparations such as wall openings, ducts, etc.for laying of the power and control cables up to the switchgear must already be complete. Compliance with the conditio