写真机故障（Photo machine fault）.docVIP

写真机故障（Photo machine fault） Lecai in spray process, ink, low resolution Date of release: 2008-1-25 source: Click: 1603 Fault reason: 1, check the color calibration Lecai ink head alignment; 2, the ink vehicle height from the surface is too high; The bridge frame gap behind the 3, the ink vehicle is too large; Resolvent： 1, re calibration, The steps are as follows: the auxiliary function menu, menu menu to save the user calibration 2, adjust the height of the bracket lecai; 3, the replacement bridge photo machine frame, four head size should be consistent; The LCD display Servioeboj:Preallocmemout Date of release: 2008-1-25 source: Click: 1096 Fault reason: Print the file is too large to cause memory; Resolvent： Replace the memory or extended memory size; The LCD screen display CBSet:Voltag Failure (2 x 0.211100 or 2 x 3ff, 11300) Date of release: 2008-1-25 source: Click: 1229 Fault reason: 1, voltage instability; 2, the bottom line is not connected; 3, the car plate is damaged; Resolvent： 1, use the multimeter to detect the voltage, recommend the use of UPS regulated power supply protector to voltage stability; 2, check whether the ground connection is good, under normal circumstances, the ground should be apart from the ground -1.2m; 3, such as the method of the problem still exists, please replace the car plate; The LCD screen display Bad Carriage Paper Sensor Date of release: 2008-1-25 source: Click: 1318 Fault reason: Port 1, test paper and ink jet plate loosening cable; 2, internal short circuit damage caused by the test paper; Resolvent： 1, turn off the power, test paper cable restart after wiping with alcohol; 2, the replacement of a paper sensor; The LCD screen display Carriage Axis Failure Date of release: 2008-1-25 source: Click: 1197 Fault reason: 1, damage to the belt pulley and the copper sleeve caused by excessive resistance; 2, the service life of the motor for 800-1200 hours, The use of time beyond this range may cause the damage to the motor; Resolve