局部放电UHF检测仪校准方法研究-电测与仪表.docVIP

局部放电UHF检测仪校准方法研究 周玮1，张传计2，张军1，梁星3，汪泉1 中国电力科学研究院，武汉 430074；2. 华中科技大学 电气与电子工程学院，武汉 430074；3. 国网重庆市电力公司电力科学研究院，重庆 401123） 摘要：针对GIS开展的UHF法局部放电检测是目前主流的带电检测方法之一，现阶段局部放电UHF检测仪偏重于对局部放电的定性判断，迫切需要建立量值溯源链并评价检测结果的可信度。本文参考IEEE推荐的电场强度校准方法，对局部放电UHF检测仪关键参量的量值溯源方法和平台进行了研究。对电气设备内部的电场信号采样，根据示值与场强的对应关系换算出被试品测得的电场强度。通过校准平台，将被试品与标准电场强度进行比对，得出被试品的测量误差为-3.74dB~+2.98dB。试验表明基于传递标准和稳态电场校准局部放电UHF检测仪主要参量的方法是可行的。 关键词：局部放电；UHF；电场强度；校准； IEEE标准 中图分类号：TM937 文献标识码：B 文章编号：1001-1390（2016）00-0000-00 Study on calibration method of UHF partial discharge detector Zhou Wei1, Zhang Chuanji2, Zhang Jun1, Liang Xing3, Wang Qun1 (1. China Electric Power Research Institute, Wuhan 430074, China. 2. School of Electrical and Electronic Engineering, Huazhong University of Science and Technology, Wuhan 430074, China. 3. Electric Power Research Institute of State Grid Chongqing Electric Power Company, Chongqing 401123, China) Abstract：Using UHF methods to carry out partial discharge detection in GIS is now one of the main partial discharge detection methods. However, PD UHF detector is biased towards the qualitative judgment of PD, and it is urgent to establish the traceability chain of detector and estimate the reliability of detection result. Referring to the electric field strength calibration methods recommend by IEEE, this paper studied the value traceability method and platform of the key factor of PD UHF detector. Sample the electric field signals in inter electrical equipment at the given frequency and convert them into electric field strength according to the relationship between indicating value and electric field strength. The experiment comparing the sample and the standard electric field strength to get the measurement error was done through the calibration platform, and the measurement error arrangement of the tested sample is-3.74dB~+2.98dB . The experiment indicated the method calibrating the key factor of PD UHF detector based on transfer standard and steady-state f