为2016端口描述.docVIP

Display interface的显示信息本次工作希望统一Ethernet接口的信息，建议如下：[1] GigabitEthernet3/0/1 current state : DOWN[2] IP Sending Frames Format is PKTFMT_ETHNT_2, Hardware address is 00e0-fc00-0010[3] The Maximum Tra被过滤广告nsmit Unit is 1500[4] Media type is not sure, loopback not set[5] Port hardware type is No Connector[6] Unknown-speed mode, unknown-duplex mode [7] Link speed type is autonegotiation, link duplex type is autonegotiation[8] Flow-control is not supported [9] The Maximum Frame Length is 1536 [10] Broadcast MAX-ratio: 100%[11] Allow jumbo frame to pass [12] PVID: 1[13] Port link-type: access [14] Tagged VLAN ID : none [15] Untagged VLAN ID : 504 [16] Last 5 minutes input rate 229 bytes/sec, 2 packets/sec Last 5 minutes output rate 25 bytes/sec, 0 packets/sec [17] Input(total): 34764 packets,bytes 1021 broadcasts, 0 multicasts, 0 pauses[18] Input(normal): 34764 packets,bytes 1021 broadcasts, 0 multicasts, 0 pauses [19] Input(error): 0 input errors, 0 runts, 0 giants, 0 throttles, 0 CRC, 0 frame, 0 overruns, 0 aborts, 0 ignored, 0 parity errors[20] Output(total): 1630514 packets, 525467915 bytes 774493 broadcasts, 822714 multicasts, 0 pauses [21] Output(normal): 1630514 packets, 525467915 bytes 774493 broadcasts, 822714 multicasts, 0 pauses [22] Output(error): 0 output errors, 0 underruns, 0 buffer failures, 0 aborts,0 deferred, 0 collisions, 0 late collisions, 0 lost carrier, 0 no carrier 注意：统计项中不支持的项目填写：-即：如果产品对deferred,collisions, late collisions, lost carrier, no carrie不支持显示结果如下：Output: 0 output errors, 0 underruns, 0 buffer failures, 0 aborts,- deferred, - collisions, - late collisions, - lost carrier, - no carrier [1] 接口状态 显示硬件链路的状态[2] 接口的输出帧封装类型和MAC地址 显示接口的删除帧封装类型和MAC地址[3] 接口的最大传输单元 显示接口的最大传输单元[4] 端口的连接线类型和环回状态 显示接口的连接线类型和环回状态[5] 端口的连接器硬件类型 显示接口的连接器硬件类型[6] 端口的实际速度和双工状态 显示端口的实际速度和双工状态[7] 端口是否是速度、双工的自协商配置 显示端口速度、双工的自协商配置[8] 端口流控状态 显示端口的MDI类型（不是缺省值的情况显示）[9] 端口可以正常转发的帧长度 显示端口可以正常转发的帧长度[10] 端口的广播抑制比 显示端口的广播抑制比