坡道式汽车库（Ramp garage）.docVIP

坡道式汽车库（Ramp garage） 4 ramp garage 4.2 ramp garage design 4.2.1 ramp automobile can be according to the specific conditions of project selection in the ramp type, outside the library and library inside and outside the straight ramp type garage; one-way spiral ramp type and double row spiral ramp and jump layer spiral ramp garage; two segments and three segments of staggered garage; and the straight slope shape Oblique floor, plate and spiral, oblique floor, plate and other garage. 4.2.2 ramp garage, in addition to the spiral ramp type, should make its ramp system in each floor on the turnover of the driveway, the formation of the upper and lower continuous access, and should prevent the upper and lower traffic cross. 4.2.3 should not be used outside the garage for straight ramp garage. 4.2.4 Cuoceng garage floor ramp is divided into two sections, the two section of the horizontal distance between the vehicle in the parking floor for the 180 degree turn, between two ramp distance from the centre line shall not be less than 14m. 4.2.5 three Cuoceng garage must limit vehicle routes. 4.2.6 Cuoceng garage floor space can be overlapped, but overlapping size should not be greater than 1.5m. 4.2.7 double row spiral ramp type garage should be used in the left outer ring upward counterclockwise running downward, should adopt the inner road, outer ring radius and width according to article 4.1.10 of this code values appropriate to increase the end of Po Daoyi arranged in the main building or irregular plane convex part. When the 4.2.8 is on a spiral ramp garage, the entrance and exit on the floor should be straight, and its ramp should be near the center of the building plane. 4.2.9 sloping slab car garage, its floor slope shall not be greater than 5%. 4.2.10 floor plate garage with oblique diagonal parking, the parking spaces to the angle between the longitudinal midline midline and oblique floor should not be less than 60 degrees. 4.2.11 rectangular inclined plate type garage