坡起（Slope）.docVIP

坡起（Slope） The concrete steps are as follows: (1) hit the right light into the subject. We should pay attention to road margin (30cm), it is the same with pull over, slowly push the front wheel to the right, 1/3 at the roadside (i.e. roadside 1/3 at front right up), about the position of the judge, can see right in the mirror surface line position, the right side of the car to press / white line on you can, and then back to positive direction. Climbing process can give oil, you can not give, control the speed, easy to find their own point on the line. (2) keep the distance of the road climbing up, and the point below stops. At the designated point, use the mirror in the front right corner of the car. That is when the car front right corner mirror and the point of fast line level signal rod (about 1 fist), trample brake stopped (the fixed position, can also be determined by the position of the radio car, bar above the upper right corner of the human eye and 3.1). Stop the brakes and take the gap immediately after you stop. (3) the slope rises. First, the left light. The starting point is two stops.. Right foot first to oil the engine speed to 1500 ~ 2000 rpm (rotation speed below 2K are not H-Car, slightly too little also all right), then right foot stays in this position (1 stops); then the left foot to lift the clutch contact point, the front of Yang, the left (keep still 2 stop); and then release the parking brake (1 move), refueling vehicle. As soon as the end of the car is over the slope, the 2 gear is added. Then Ill share with you the understanding of this project. Slope starting process (third steps), mainly to avoid the beginning of the car slide and flameout. (1) the reason of vehicle, is not enough to lift the clutch contact point (low lift clutch), or no oil (idle car itself is low, not enough to drive the vehicle) under the condition of the hand brake is released. (2) there are two reasons for flameout. First, the emergence of the car after the rapid brak