起步熄火原因（Starting flameout reasons）.docVIP

起步熄火原因（Starting flameout reasons） 1. In the process of vehicle braking and cornering, the vehicle is high grade and low speed, easy to flameout; 2. Low starting time, easy to stall when engine speed and low speed; Solving measures: 1. During the running of the vehicle, in time of braking and turning, control the speed and hang the low gear in time to avoid the shake and flameout of the vehicle; 2. Starting time, when the clutch pedal, the throttle with oil to improve engine speed. The clutch is too fast and the throttle is too small. Slow down the clutch and push the accelerator up a little. Clutch bit by bit, according to my coachs words, that is, according to the thickness of a piece of paper slowly lifted, more practice a few times you can find the feeling, do not worry Hello, my friend! Automobile engine flameout for several reasons: 1, out of gas; 2, change to high gear at low speed; 3, mechanical failure; 4, starting clutch up too fast; 5, no change into neutral parking brake. Start the car on the gear No speed, no clutch Wait Why does the engine stall? Many drivers initially thought to be due to heavy braking, engine and transmission did not separate cause, so I did not pay attention, but then the car in place when starting the engine can not be normal, idle, and easy to flameout. In fact, excluded from the perspective of fault engine flameout: according to the above phenomenon, maintenance personnel determine the engine as no idling fault, adjusted according to the requirements of the engine idle speed, when the engine speed can reach 1800r/min stable, less than 1800r/min when the engine flameout gradually. The staff were checked for the CO concentration screw and no abnormalities were detected. According to past experience, maintenance personnel on the ignition system and oil supply system were detected, but also found no abnormalities. Finally, we tested the control current of the idle stabilizing valve, and found that its value is 400 + 30mA, standard val