《工程测量》（Engineering Surveying）.docVIP

《工程测量》（Engineering Surveying） Engineering Surveying 1. the main control points of the circle curve are (). A. starting point (straight point), turning point (curve midpoint), end point (circle straight point) B. intersection point (straight point), midpoint (curve midpoint), intersection point (circle straight point) C. intersection point (straight point), turning point (curve midpoint), intersection point (circle straight point) D. starting point (straight point), middle point (curve midpoint) and end point (circle straight point) Full marks: 4 2. deformation observations must be based on stable, stationary points called (). A. deformation point B. benchmark C. work point D. flag point Full marks: 4 3. in the topographic map elevation is 26m, 27m, 28m, 29m, 30m, 31m, 32m contour lines, you need to bold contour line for () M. A. 26, 31 B. 27, 32 C. 29 D. 30 Full marks: 4 4. the elevation of adjacent contour lines on topographic map is large, then the slope of terrain. A. flat (small) B. steep (large) C. invariant D. is wrong Full marks: 4 5. on a topographic map, the more sparse the contour line, the more likely the state of the landscape is A. slopes evenly B. the smaller the slope C. the greater the slope D. is wrong Full marks: 4 6., the orthographic projection map, which reflects the plane position of the ground object and reflects the elevation of the ground, is called () A. plan B. section C. image D. topographic map Full marks: 4 7. the main form of building deformation is (). Horizontal displacement, vertical displacement and fracture of A. B. tilting and flexing C. horizontal displacement, vertical displacement, tilt and flexure Both D. are right Full marks: 4 8., the flat meter mapping is the use of () principle, graphic horizontal angle, stadia distance measurement and elevation, and then will be measured on the map of the exhibition of a combination of observation and drawing method of mapping. A. orthographic projection B. similar shape C. analytic meth