喷墨打印机连续供墨系统安装使用注意事项（Notes on the installation and application of continuous ink supply system for ink jet printer）.docVIP

喷墨打印机连续供墨系统安装使用注意事项（Notes on the installation and application of continuous ink supply system for ink jet printer） Good tx800fw is not a simple matter, expect to use tx800fw like ordinary ink like worry is not realistic. Even for system like a Liema, ride well, you will enjoy the fun of printing arbitrary, control is not good it will not only give you a rush, and may even allow the early demise of your printer! For CISS ink Early tx800fw ink is not easy, in ink after the need to use a syringe or vacuum pump to draw outside the cartridge in the air, and each color cartridges are required to use a syringe, not only trouble, it will often make the operator hands are full of ink. Now the most tx800fw ink will be much simpler, most tx800fw are already filling the ink, ink by using syringe funnel (usually in the syringe before a pipe), the ink from the ink injection hole outside the cartridge into the line. However, for the first time an ink filling empty tx800fw, vacuum is often unavoidable steps, in addition, if even for system in the storage and transportation process, the hose into a lot of air, also need to be pumped out of the air, even for the system to work properly. The first time in the air, with ink in the system, not too full, about 50% can be installed, so as to ensure the vacuum air is drawn. Then other holes are sealed cartridges, leaving only the ink injection hole (some from the air holes in the pump or vacuum pump) inserted into the syringe, the syringe nozzle must be in close contact with the ink injection hole. Hold the seal and start pumping air from the cartridge (Fig. 1). When the suction is released to a certain extent, the ink will automatically flow into the inner cartridge under the influence of atmospheric pressure. The orientation of cartridges should also pay attention to, usually connected with a hose that up, so that the ink flows into the first balance device in ink cartridges and mouth parts, make sure there is no air into the print head.